Carbide Drill for SR Machining NC Program Creation Software

Carbide Drill NC Program Creation Software for SR Machining is application software for creating programs for NC machining with MOLDINO's Carbide Drill for SR Machining (WHSR). Please download the program below and use it.
(The data is compressed in ZIP format, so please use it after decompressing it. It is not necessary to install it on the OS.)

Depending on the browser you are using, you may not be able to open the Excel file properly. In that case, please try using a different browser, or select "Save As" after selecting the above link, save it to your desktop, etc., and then open the file. We apologize for the inconvenience, but thank you in advance.
Since this software is created in Excel using macros, it will not work unless macro settings are enabled. Please enable macro settings. Also, please note that we are not responsible for any problems caused by changing settings.

Program creation example

Here is an example of creating a main program. The creation method uses ATC in the ABS directive.
*The programming code may differ depending on the machine used.
T1
M06
G90G17G54G00X0.Y0.(Processing position)
G43Z50.H01 (set initial point)
M07 (coolant ON)
M98P100
M09 (coolant off)
M05
M30

●Caution

Please note that we will not be held responsible for any troubles that may occur on the machine due to the NC program created.
Only FANUC control devices can be used.
When using an NC program, be sure to thoroughly check the operation by dry running, etc.
Before use, please read "Safety when using cutting tools" and "Precautions when using cutting tools" in our catalog.

Carbide Drill for SR Machining NC Program Creation Software
go to download form

About when you cannot download when using Microsoft Edge

What to do if the message "Macro execution has been blocked" appears